✈️
Miltech Simulations Documentation Hub
Miltech Simulations MV-22B Tiltrotor
Miltech Simulations MV-22B Tiltrotor
  • 👋Welcome to the MV-22B
  • Product Information
    • ℹ️Introduction
    • 📃Glossary
    • ❗Disclaimer and Credits
    • 🆘Product Support
    • 📄PDF Manual
  • Product Guides
    • ‼️Important Need-to-Knows
    • ⏱️Quick Start Guide
    • ✅Normal Procedures
    • ⚠️Other Procedures
      • Blade Fold/Unfold and Wing Stow (BFWS) Procedures
      • Single-Engine Operations (Engine Failure)
      • APPR using NAV1/NAV2 (ILS Approach – Glideslope and Localizer)
      • In-Flight Refueling
      • Fuel Dumping
    • 🗃️Hardware Binding Guide
  • Aircraft and Systems
    • ✈️Overview - Exterior
    • ✈️Overview - Cockpit
    • ✈️Aircraft Systems
      • 🖥️Multi-Function Displays (MFDs)
        • Primary Flight Data (PFD)
        • Hover Mode (HVR)
        • Navigation Functions (NAV)
        • Forward-Looking Infrared Camera (FLIR)
        • Status Functions (STAT)
        • System Functions (SYST)
      • 🖥️Center/Control Display Unit (CDU)
        • CDU - Menu 1
        • CDU - Menu 2
        • Flight Plan (FPLN) Menu
        • Waypoint (WYPT) Menu
        • Mission (MSN) Menu
        • Timer (TIMER) Menu
        • Exterior Lighting (LTS) Menu
        • Status Functions (STAT) Menu
        • Engine Instrument Crew Alerting System (EICAS) & Standby Flight Display
      • 🎛️Autopilot Console
      • 🎛️Communications Console
      • 🖥️Standby Instruments
      • 🎛️Overhead Panel
      • 🎛️Center Console
      • 🎛️Side Consoles
    • 🗺️FS24 - Navigation Systems
    • ⚙️Performance and Limits
    • 📦Cargo Load Capabilities
Powered by GitBook
On this page
  1. Aircraft and Systems
  2. Aircraft Systems
  3. Multi-Function Displays (MFDs)

Hover Mode (HVR)

PreviousPrimary Flight Data (PFD)NextNavigation Functions (NAV)

Last updated 9 months ago

Hover Mode is only available starting V1.4.0

This page contains a special view of the Primary Flight Display specific for Hovers. To access the HVR Page, click on the PFD Button (Top left button) of any Multi Function Display in the MV22.

  1. Nacelles Indicator: Indicates the angle of nacelles in degrees. It also visualizes the “Conversion Corridor” (See Performance for more details). Upper and lower limits based on airspeed are shown as two red indicators, safe area is in green.

  2. TO CARGO Display: Will display only if external cargo has been selected. Displays distance and bearing to cargo.

  3. Compass Rose

  4. Cargo Position Indicator: Displays where is the cargo located with respect to aircraft, if external cargo has been selected.

  5. Radio Altitude and Vertical Speed Indicator: Limited to maximum altitude of 500ft and vertical speeds of +500/-500. Beware of VRS Conditions

Vertical speeds inferior to 1500 ft/min that may result in Vortex Ring State (VRS). Avoid the red line when flying at low speeds/high nacelle angles.

  1. Interm Power: Green = normal, Yellow = caution, Red = warning, Red Blinking = engine overstress

Engines cannot sustain full throttle for longer than 60 seconds. If Interm Power is blinking, reduce throttle to at least 98% for a few seconds to reduce stress on the engines.

  1. Horizontal Speed Indicator and Flight Path Vector Indicator: This indicator will display the absolute value of the horizontal speed of the aircraft while in hover. The white rotating indicator displays the direction of flight of the aircraft (eg. direction of the speed vector).

  2. Hook Status Display: Displays the current status of the hook and any loads attached to it. "HOOKED" indicates load has been successfully picked up by the aircraft, "HOOK BROKE" indicates the sling load has broke due to overstress.

  3. Hook Indications Display: Displays important information regarding status of the sling loads - such as hover timers, pull up indications, and speed indications.

✈️
🖥️
Hover Page